LaboCosmetica FIERO 250ml (Super Finish Genuine Polish - Primer For Coating)

Product DescriptionSuper finish genuine polish - Primer for coating#FIERO is an innovative and refined water based primer without waxes or silicones. It does not cover defects but eliminates them leaving a pure and real finish with an extreme and deep gloss on the treated surface, creating the ideal condition for the application of nanoceramic coatings. Our primer was designed specifically to prepare the surface for the next coating application phase Thanks to the innovative S.A.M. (Self Assembled Monolayer) technology, it guarantees a strong and lasting link between the surface and the applied nanoceramic coating, including our sealant #Cupìdo. The traditional primers that use resins and fillers to get an excellent finish, need a long time to link on the paint, usually from 6 to 12 hours of waiting! With #FIERO all this does not happen because it allows the application of the chosen coating immediately after the finishing phase, thus saving the detailer a lot of time. #FIERO is a sincere super refiner, does not fear IPA and is compatible with all coatings that require UV lamps without any drop in Gloss. #FIERO in fact contains neither resins nor fillers (fillers) or waxes, its formula is composed of a careful selection of synthesized abrasives that adapt to the surface thanks to the innovative technology "Adaptive Abrasive Technology." This technology allows to obtain a finish always perfect and pure on both soft and hard paints. #FIERO allows to shorten the processing time on any type of paint and expresses its maximum finishing capacity in the presence of reflow sensitive, soft and sticky surfaces. While, in the presence of hard or ceramic surfaces, it allows to close the work in only 2 steps in combination with our #AUDACE compound. For these reasons #FIERO is the solution that the detailers were looking for. The whole #Labocosmetica® polish range is odorless and "VOC FREE".Recommended Pads:Yellow or Black pad.Instructions For Use:With rotorbital spread the product homogeneously at a constant speed of 4.5 on an area of ​​40x40cm until depleted primer recommended medium soft yellow or soft black.Our primer was designed precisely to prepare the surface for the subsequent coating application phase thanks to the innovative SAM technology (Self Assembled Monolayer), guarantees a strong and lasting link between the surface and the applied coating nanoceramic including the our sealant CUPÌDO. Traditional primers that use resins and fillers to achieve an excellent finish take a long time to bond to the paint, usually 6 to 12 hours of waiting! With FIERO all this does not happen because it allows the application of the chosen coating immediately after the finishing phase , thus saving the detailer a lot of time. FIERO is a super sincere finish, it does not fear IPA and is compatible with all coatings that require UV lamps without any loss of Gloss .► FIERO in fact it does not contain resins or fillers (fillers) or waxes, its formula is composed of a careful selection of synthesized abrasives that adapt to the surface thanks to the innovative “ Adaptive Abrasive Technology “. This technology allows to obtain a always perfect and pure finish on both soft and hard paints .► FIERO allows you to shorten processing times on any type of paint and expresses its maximum finishing capabilities in the presence of sensitive surfaces such as reflow, soft and sticky. While, in the presence of hard or ceramic surfaces, it allows you to close the job in just 2 steps in combination with our compound AUDACE . For these reasons FIERO is the solution that detailers were looking for.