Garage Gate Door Remote Control Universal Receiver 12V 24V 9-30V Controller Switch 300-900MHZ 433.92 433mhz Opener

Universal Multi frequency 300-868mhz garage gate door receiverWorking Frequency : 300MHz-868MHz(Rolling Code & Fixed Code & Learning Code)300MHz310MHz315MHz318MHz390MHz433.4MHz433MHz433.92MHz868MHz868.3MHz868.8MHzCan identify ALL Fixed Code (2262, 2260, 2264, 5326, M1E, M5Eand so on). All Learning Code (1527, 2240, 6P20B, 6P20D and so on)Rolling Code (HCS301, HCS300.HCS200, HCS201, HCS100,HCS101 and so on)Specifications1，Name：RX MULTI Receiver2，Operating Voltage：AC/DC 9V-30V3，Channels：24，Frequency：300MHz - 868MHz5，Code：Rolling and Fixed Code & Learning Code6，Distance：30m-120m7，Size：56mm46mm20mm8，One receiver can work with 400 Remote Control9，It don’t interference other remotes and receivers.10，Brand selector: With 8 dip switches user can make different combination for different remote brands.11，Uses: Receiver is designed to control any gate automation system, burglar alarm system, electric doors, windows, lifting equipment, gateways, lifting devices. This is an easy to use, good looking, low power consumption and is easy to connect to your existing system.12，Power Input Selector: This receiver can work at AC/DC 9V~30V. However, it’s better to change the PIS according to the power input. If the input is great than 24V, shorten pin 2&3; shorten 1&2 if input less than 24V.Connect your motor or your controller to useReplacing old garage control systems, or for adding more remotes to control garage doorsHow to dial the code?You can switch the dial code you need according to your remote control brand and frequencyHow to program?1, Brand selector: With 8 dip switches user can make different combination for different remote brands. 2, Power Input Selector: This receiver can work at AC/DC 9V~30V. However, it is better to change the PIS according to the power input. If the input is great than 24V, shorten pin 2 and 3; shorten 1and 2 if input less than 24V. 3, Programming procedure: 1) Select the correct brand for remote to be programmed by moving dip switches UP or DOWN. For 433,92Mhz Rolling Code remote controls, just move Dip-switch 5 UP. ( Contains manual) 2) Press the learn button. The will LED turn on. 3) Press the button on the remote, the LED flashes 4 times. It means that remote control was programmed successfully. 4) Repeat step 2 for another button. 4. The 2-nd channel programming procedure is the same. 4. Erase all data from the memory card: Press and hold either learn button. The LED will start flash. Keep this button pressed, until the LED will turn off. All saved data in the memory card will be erased permanently and can not be recoveredRemote control transmitterFrequency: 433/433.92mhzCode: Learning code EV1527modern, stylish, compact design which fits perfectly in your pocket.LED IndicatorCompact pocket sizedIncluded key ringIncluding battery