ANENG | Smart Wireless Wall Switch 50-60Hz ANENG Smart Home Push Button Transmitter Long Distance Control Interruptor Wall Panel Tools

ANENG Smart Wireless Wall Switch 50-60Hz Smart Home Wireless Push Button Transmitter Long Distance Control Interruptor Switch Control ToolsPay attention to safety precautions1. Wide voltage adaptability: The rated voltage covers 110V~240V AC and can be used in regions with different voltage standards, with strong applicability.2. Flexible load power: The load power of each line ranges from 10W to 100W, which can meet the control requirements of various small and medium-sized power devices.3. Strong adaptability to work environment:The working temperature range is -20 ℃~+70 ℃, and it can work normally in both severe cold and high temperature environments.The relative humidity is suitable for 10%~93% (non condensing), and it can also operate stably in humid environments.4. Energy saving and low consumption: Energy consumption is less than 0.02W, and long-term use will not generate excessive electricity consumption.Excellent battery performance:5. The battery life can reach 100000 times, with a long service life and reduced frequency of battery replacement.Adopting 3V CR2032 button battery, which is common and easy to obtain.6. Practical remote control distance: In open and interference free environments, the remote control distance can reach up to 10 meters, which can meet the remote control needs of daily homes and small places. In actual use, it will be adjusted according to environmental interference to ensure reliability.Wireless Remote Control Switch Product Parameter Indicators：Rated Voltage 110V~240V ACLoad Power10WOperating Temperature-20℃ to+70℃Operating Frequency50~60HzEnergy ConsumptionLess than 0.02WRelative Temperature10%~93%(non-condensing)Endurance Time100,000 cyclesReceiver Battery Type3V CR2032 button cell batteryRemote Control RangeWithin 10 meters(open space without interference,actual range depends on the interference in the usage environment)The parameters are for reference only, and the actual measurement of the specific equipment shall prevail!Package Include:According to your choiceLearning Method for Remote Control Function1. Switch pairing tutorialPress and hold the wiring host button for 3 seconds, the host indicator light will flash 3 times before entering pairing mode. Release the button, hold down the remote control button, and wait for the host indicator light to flash 3 times to indicate successful pairing.Note: Only one remote control can be paired at a time, and multiple remote controls can be paired one by one.To better observe the changes in the indicator lights during pairing, it is recommended to press the switch with a screwdriver or other insulating material before the panel is fastened for pairing.2. Method for clearing remote control codePress and hold for 10 seconds, the light flashes 5 times, and the code is successfully clearedThe parameters in this manual are subject to change without prior notice;Our company does not assume responsibility for accidents and hazards caused by user errors;