Magigoo Bed Adhesive – Original Supergrip PA PC PP PPGF HT Flex & Metal

Magigoo is a purpose-built build plate adhesive for FDM printing that improves first-layer reliability, reduces edge lift, and makes print removal more predictable once the plate cools. This single product page lets you choose the formulation that matches your filament and build surface, from everyday printing through engineering materials and specialised filaments, so you get confident adhesion during the job without turning removal into a struggle afterwards.Applied as a thin, even layer, Magigoo supports clean, consistent starts and helps protect your build surface from excessive scraping. Once the print finishes and the plate cools, parts typically release more easily, which is especially helpful on larger footprints and warp-prone materials. Magigoo is also available with the Magigoo Glide Roller, a roller-style applicator that helps you lay down a thin, even layer quickly across the print area, which is especially handy for larger parts or frequent re-application.Choose the right Magigoo for your materialMagigoo is available in several formulations, each tuned for the way different filaments behave on the build plate. Selecting the right option helps you get dependable first-layer hold while hot and easier release after cooling, particularly with materials that are prone to warping, shrinkage, or inconsistent adhesion on certain surfaces.FormulationBest forBuild plate notesOriginalPLA/ABS/PETGGeneral-purpose option for common build surfacesSupergripPLA/ABS/PETGSpecially formulated for textured PEI spring steel plates on Bambu Lab, Creality Ender, and other modern printersPANylon (PA) and PA-CFWorks on all build platesPCPolycarbonate (PC) and PC-CFWorks on all build platesFlexFlexible filaments like TPU/TPE/TPCTo remove the parts simply apply a bit of water around the edge and move the part loose with your hand.PPPolypropyleneWorks on all build platesPP-GFGlass-fibre reinforced polypropyleneWorks on all build platesMetal 316L316L metal-filled FDM filamentsWorks on all build platesHTPEEK, PEKK, PPSU, Ultem, PCTGWorks on all build platesHow to useClean and dry the build plate.Shake the bottle, then press the nib to the plate to start flow.Make a few small dabs to place dots of adhesive, then spread into a thin, even film. There is no need to keep the nib pressed down continuously.Print as normal, then allow the plate to cool before attempting removal.Reapply when needed. Cleaning method depends on your plate and formulation.Important noteThe applicator uses a spring-loaded valve that only opens when the nib is pressed against the build plate. You only need brief presses to create a few dots of adhesive, then you can spread them out. Please do not squeeze the bottle like a ketchup bottle, as this can cause the applicator to pop off.If you need a little more flow, you may apply a very gentle squeeze, but only while the nib is firmly pressed on the build plate. Do not squeeze the bottle at any other time, especially when the cap is off, as adhesive may eject from the bottle unexpectedly.