Aideepen | 3.2-3.7V 10M Solar Panel with Remote Control Microwave Radar Human Body and Light Induction Control Multi-mode Timing DIY Panel

Product features:1.Compatible with 3.2V lithium iron phosphate battery 3.7V lithium battery2. Can be used for solar integrated street lamp modification or maintenance3. Microwave induction full light 10 seconds to light4. Multi-mode low light long light, can be timed5. Easy to use, suitable for a variety of DIY operationsProduct parametersRed board:Rated voltage: 3.2V/3.7VApplication LED voltage: 2.8V-3.3VPower: Solar panel maximum input: 5V-6V/Sensing mode: light-controlled sensing + radar human sensingInduction time: high light about 10 seconds + low light long light on/offSensing distance: about 5-10 metersFunction: timing radar functionModule size: 65mm20mmRemote control size: 104mm37.5mmFunction: timing rear-shell radar functionGreen Board:Rated voltage: 3.2V/3.7VApplication LED voltage: 2.8V-3.3VLED power: Solar panel maximum input: 5V-6V/Sensing mode: light-controlled sensing + radar human sensingInduction time: high light about 10 seconds + low light long light on/offInduction mode: microwave radar inductionSensing distance: about 5-10 metersModule size: 84mm25mmRemote control size: 104mm37.5mmFunction: After the timing can only adjust the brightness, can not turn the radar modeInstructions for use:Please connect the battery first, then the LED light, and finally the solar panel, this control board does not have over-charge and over-discharge protection, please install a good protection board on the battery to prevent over-charge and over-discharge;This control board is not equipped with overcharge and overdischarge protection. The battery needs to have its own protection board, compatible with 3.2V lithium iron phosphate battery 3.7V lithium battery, which can be used for solar integrated street lamp modification or maintenance.Microwave induction full light 10 seconds to light. This product is equipped with the remote control there is no battery. You need to buy AAA battery locally.Test notes:1. When testing the sensor mode, there should be no moving objects within 12 meters, including hands and feet, otherwise it will be detected2. When multiple induction modules are together, they will interfere with each other, resulting in insensitive induction or false triggering3. The surface of the patch part is the emission surface, and self-adhesive and glue can not be stuck on this side, otherwise the induction distance will be shorter4. The distance between the front and back of the sensor and the metal is not less than 2CM5. The surface of the patch parts can not be shielded by metal, otherwise the detection signal will not be transmitted, resulting in a shorter induction distance6. Inductive signals can penetrate glass and plastic walls.Product list:Module *1Remote control *1(without battery)