24V 36V 48V 750W 1000W 26A-35A E-bike Brushless Motor Controller with S866 LCD Display Throttle PAS for E-Mountain Bike Scooter

Note: Error code E06 occurs, the product defaults to 36V, this is an undervoltage situation, you can manually adjust the meter to adapt to 24V, or check the battery and adjust it to 24V and wait for about 10 seconds. Do not touch anything during this period. It will convert automatically. Video link: https://video.aliexpress-media.com/seller/play/5000264806825.mp4Note: If error code E07 occurs, the power assist PAS cable (red, yellow, black) and the throttle cable (red, green, black) are connected incorrectly. Follow the wiring video link, or rewire the throttle cable and adjust the throttle cable (red, green, black) signal line. Reference videos: https://video.aliexpress-media.com/seller/play/5000298772350.mp4 and https://video.aliexpress-media.com/seller/play/5000298772350.mp4Note: If error code E10 occurs, it indicates a loose connection at the instrument panel connector. Try unplugging and replugging the cable. Refer to the video website: https://video.aliexpress-media.com/seller/play/5000376402889.mp4Voltage:24V/36V/48VRated Power:750W-1000WCurrent: 26-35ACase Dimensions:125.33cmHall: 6PinPAS: 3PinDisplay: 5PinThrottle: 3PinMOSFET: HY3410Functions: Headlight Power Supply, Throttle, protocol 2 instrumentation (display), 6-pin Hall Effect sensor, dual low-pressure brake (E-brake), power assist (PAS), self-studyNote: the product has only one controllerPacking list:1 x S866 LCD display1 x controller1 x pas sensor 1 x throttleNote:Each cable is marked with different colors for different purposes.Q1. What voltages does this controller support?A: This controller supports 24V, 36V, 48V batteries.Q2. Is my motor a brushless motor? How can I tell?A: This controller is for brushless motors. Brushless motors are 3-phase wires + 5/6 Hall wires.Q3. The LCD displays an E06 error code after I install it, what is the problem?A: This is a battery undervoltage code, check if the battery is full and also please set your voltage in P03 in the LCD settings.Q4. The LCD shows E07 error code after my installation, what is the problem?A: This is a motor fault code, please check if the hall sensor and phase wire are connected correctly. And drive the motor with 4-5 high speed, E07 will disappear.Q5. My brushless motor only has 3-phase wires, can I use this LCD kit?A: We do not recommend LCD kit, but Hall will show E07 error code. We recommend our S810 LED panel kit, you can search in our shop.Q6. My motor reverses, what do I do?A: Please plug in the learning wire (auto-detect) to check your motor parameters for normal drive and compatibility, disconnect and plug in again to change the motor drive direction.