Servo Gimbal Bracket Dual 2-Axis Mini Plastic FPV Gimbal Bracket Model Airplane Camera Intelligent Balance Car

p{margin-block-start: 0; margin-block-end: 0}

Product Introduction The two degree of freedom servo pan tilt bracket can move horizontally and vertically. When combined with the servo, infrared sensors or ultrasonic distance sensors can be installed to form an integrated detection device. Other sensors can also be installed to complete various novel interactive works through the servo controller, such as model aircraft, robotic arms, robots, video surveillance probes, etc. be careful!!! It's not a finished product, you need to assemble and DIY it yourself. It's sold as a piece, not a finished product, you need to assemble it yourself. Thank you for understanding. If you don't understand, please ask customer service Equipped with SG90 steering device, 9g plastic gear servo servo servo servo: The rocker arm of the steering device needs to be cut off a little before installation, and the installation of the steering device on the base also requires modification of the rocker arm (removing the edge of the circular hole, and then placing or trimming the rocker arm into the steering device arm)! At present, this PTZ can only install 28 * 28 camera modules and cannot install 32 or 38 size cameras. (Please note that the rudder arms of the servo need to be trimmed.) This 2-axis plastic gimbal weighs 17 grams and is suitable for 9g-12g servos. It has a beautiful appearance, precise manufacturing, no virtual position, and no shaking. It is equipped with servo cable fixing clips. The product is shown in the picture, consisting of 4 nylon plastic parts, including screws. Need to assemble by oneself. Note: Due to various factors such as the brightness of the monitor and lighting, the actual color of the item may differ slightly from the photos displayed on the website. 2. Please allow for slight manual measurement deviations in the data. Thank you for your understanding.