MJJC | Horse Race Running Water COB LED Strip Lights 24V 360leds/m WS2811 Pixel Tape Lamp Warm Cool White Stripe 2.4G RF Remote Control

FeaturesProduct Name: WS2811 IC COB Horse Race Led StripLED Type: COB LED DiodesLED Qty: 360LEDs/MPCB width:10mmMax Power: 10-12W/MWorking Voltage: DC 24VColor: Cool White / Warm White / Natural WhiteColor Temperature: Cool White 6000K / Warm White 3000K / Natural White 4000KIP Rate: IP20 Non-waterproofConnector: 3 Pin Male & Female ConnectorIC Qty:12pcs IC per meters, 60pcs IC for 5MPackage: 5M/RollConnection:Red Wire: +24VGreen Wire:DI/DATAWhite/Black wire: GND / -24V2.4G SPI Water Flow Controller:Working Voltage: DC 24V Total output: 10A Max, 6A/Channel Max.Max Control Pixels: Up to 800 pixelsMode Effects: 7 ModesRemote: 2.4G Touch Remote ControlRemote Distance: 30MetersOutput: 2 Channel ( For 2 lines Led strips working at the same time)Battery Type: 2pcs *AAA Battery ( Battery not included)Panel Keys: Brightness UP/Down, Speed UP/Down, Mode+,Mode-, ON/OFF, Back to 1st Mode,Features of controller: Working with Push switch, and the remote can realize 4 Zone control independently.How to increase the Pixel Points ?Press "Opt" to turn off the lights firstly, then Double Press "Set" Key on the controller , it will scan IC quantity automatically. Much easier than other version.How to Pair the Remote with the controller ?Step 1: Power OFFStep 2: Power ON, within 3 seconds touch any of the Zone " I " button 3 times shortly. it means successfully when the lights blink 3 times. Otherwise try again later.DC 24V Power Supply:Input Voltage: 110V / 220V ACOutput Votage: 24V DCOutput Power: 100W / 200W/300WFeatures: No Noise, Real power output, long life-span.Advise: 1pc 24V 200W power supply to drive max 15m 24v 360leds/m running water light strips. if any big projects for longer strips, need add extra power supply each 10m.ApplicationMaking led screen,Rooms Stairs Fashion Show.led wall, advertising board. Apply to hotel, KTV, bars, advertisement company, decoration company,the city lighting project, entertainment and leisure places lighting.Connection Note:1. When the led strip is over 10m,please kindly connect power wire to the two ends of led strip, to keep the same brightness.There is wiring diagram in the following of this page.2. Make sure do "Pixel Setting" before using.Otherwise,only half led strip is working.3. Make sure pair Remote to the controller before using. Otherwise the remote is no response.