Universal 1D Car Radio Shark Fin Antenna Radio Signal Auto Aerial Suitable For Alfa Romeo 156 GT Q2 MiTo

p{margin-block-start: 0; margin-block-end: 0}Features and specifications:Shark fin antenna made from ABS plastic. It is coated in piano paint and comes in 25 colors. Features a double adhesive for a strong hold.Note:The shark bottom hole measures 10 x 6.2 cm(3.93"x2.44"). Please make sure your antenna base is smaller than that to ensure fit. If your antenna base is larger, please order the super shark as it can fit a larger base.ColorsPiano paint, ABS plasticBright surface, non-fading, durable ABS plasticPackage includes1 Shark fin antenna1 antenna cable1 double adhesive1 pair screw and nutEasy to install① Stick the double adhesive onto the bottom of the shark fin.② Remove the original antenna.③ Tighten screw and nut on the original antenna base,then test the radio.④ Carefully align the shark fin and press down for 2 minutes to assure adhesion.DimensionsShark fin: length 16.9 cm (6.7 inch), width: 7.7 cm (3 inch), height: 6.3 cm (2.5 inch)Bottom hole: length: 10 cm (3.93 inch), width: 6.2 cm (2.44 inch)Product photosFAQ:Question1:The shark same color with the original car color?Answer:The shark fin color very close the original color,however, the car due to long-term exposure to outdoor, erosion by rain and snow,the color has changed, so impossible exactly the same as color,hope you understand that.Question 2:How do i know the shark fit my car or not?Answer:Please remove the long antenna,than check your original antenna base length,width and height.Please confirm the base length and width size less than shark bottom hole size.Meanwhile,as the height of the shark antenna increases, the internal space becomes smaller and smaller.Normal base,the top size smaller than bottom size,it can be install.If the top and bottom of your base are the same size, it may not be suitable.Question 3:The shark installed on the roof have a little gap, is appropriate?Answer:The shark bottom is curved,most of sedan models no have gap,the hatchback models and SUV models roof is flat,there may be have a little gap,it does not affect the use.You can use adhesive in to the gap.Question 4:What should be note when installing?Answer:Clean around antenna base,be sure without water or dust,first connect the cable and base,test the radio signal,if it is okay,than installing,heating double adhesive with hair dryer before you install,it will become soft,viscosity will increase,only have one chance to paste,so be sure to alignment the position pressing 3 minutes after pasted,keep dry in 2 days.