1-480Min IO33H01 Timer Adjustable Disconnect Delay Controller AC 110V 220V Power-ON Delay OFF Relay Timing Switch with 50mm Wire

product feature 1: Small size2: Simple to use, wiring according to the detailed diagram3: Stable performance4: Optional with shell without shell5: Output voltage: AC110-220V Power supply voltage: AC 110-220VProduct Parameters:1. Brand2. Model: IO33H013. Output current: 7A (MAX 10A)4. Working power consumption: 43mA5. Output voltage: AC110-20V6. Power supply voltage: AC 110-220V7. Weight with shell: 29 grams8. Shell size: 57 × 35 × 20mm9. Weight without shell: 19.1 grams10. Dimensions without shell: 44 × 28 × 1.6mm11. Unified wire length: 50mm12. Maximum standby power consumption: 12mA13. Number of control channels: 1 output14. Working temperature: -25 ℃~85 ℃15. Working humidity: 5%~95% RH16. Shell: High quality shell, dustproof and flame-retardant17. Function: Delay for a period of time to stop power supply18. Control power: 1400W (maximum) incandescent lamp, 300W (maximum) energy-saving lamp19. Equipped with LED indicator light to display working status (constant light indicates working, flashing indicates delay end)20. Applicable scenarios: living room, kitchen, bathroom, bedroom, corridor, stairs, etc21. Widely used: such as exhaust fans, motors, air coolers, cooling fans, sterilization lamps, humidifiers, heaters, etc.22. 16 delay modes to choose from (1 minute, 3 minutes, 5 minutes, 10 minutes, 15 minutes, 25 minutes, 30 minutes, 40 minutes, 50 minutes, 60 minutes, 90 minutes, 120 minutes, 180 minutes, 240 minutes, 300 minutes, 480 minutes)Module function: This module is a delayed shutdown module. Stop power supply when the set delay time expires.Working status: After power on, the indicator light (PWR) is constantly on; After the delay ends, the indicator light (PWR) will continue to flash.Usage:① Set the required delay time (live streaming settings are not allowed);② After checking the wiring is correct, power on the module. After power on, the module starts working (the indicator light is always on), and when the time is up, the module stops supplying power (the indicator light flashes).If you need to turn off the module in advance during use, simply disconnect the main power supply of the module.2. Start the second delay: Power on again.Delay time selection method:① Refer to the delay method table to select the time that needs to be delayed;② According to the delay mode table, toggle the dip switch (red);③ After setting up, check the wiring and then power on.Attention: When a new delay mode needs to be set, to ensure personal safety, it must be set to power-off mode and live operation is prohibited.