difang | DIFANG 5400mAh UPS Power Adapter with LCD Screen DC12V Uninterruptible Power Supply Backup for Security Cameras

Please check you order 1pcs or 2pcs5400mAH (Factory Supply) DC12v 1.5AUPS Uninterruptible Power Supplylt can ensure that your camera can work normallyfor 3-6 hours in the event of a power outage,ensuring the safety of your propertyFit For Outdoor Waterproof UseCompatible with a variety of equipment.Widely used in audio, surveillance camera, mobile hard disk, radio, repeater and so on.See LCD Display To Know Battery Status‌Battery Level Display‌‌12:‌Green Light‌: Lights up when voltage is between 12V-12.3V, simulating 95% charge‌2‌Yellow Light‌: Lights up when voltage is between 11V-11.9V, simulating 80% charge‌2‌Red Light‌: Lights up when voltage is below 10.5V, simulating 15% charge‌Charging and discharging at the same timeUPS power supply can be the same as the ordinary power supply for the camera to power, but also for the built-in battery to charge, wait until the power failure, the built-in battery can continue to power the camera, so that the camera continues to workAbout battery installationThis UPS power supply INCLUDE batteries.DC12V Battery Power Adapter Output 12V 1.5A UPS Monitoring Power Outage Endurance Power Supply WithBattery Security MonitoringFunction12V 1.5A surveillance camera UPS power supplyIt can supply power directly to the cameraIt can store power in the built-in batteryCharging and powering can be done simultaneouslyAutomatically use the built-in battery to power the camera when there is a power failureCompatible with 18650 batteries, please carefully read the installation instructions. It is recommended that each battery has a capacity between 1000mAh and 2000mASuitable for most IP cameras on the marketGood water resistance, can be used outdoorsCaution:12V 2A power connector is 5.5mm to 2.1mm Total output current of the two 12V output ports is 2AProduct parametersRated input voltage: AC176-264VRated frequency: 50/60HzOutput port: AC plugNo-load pressure: 12.3-12.6VMaximum peak current: 2.0ARated output voltage: voltage ± 12V-DCOutput port: ACRated working current: 1.6AWorking temperature: 70 ℃~- 20 ℃,full load, normal operation.Storage temperature: - 20 ℃ to 85 ℃, with shell.Operating humidity: 5% (0℃)~90% (40℃) full load, normal operationProduct parameters labeled as 121V1.5A, which is the lowest output parameters, the adapter can support the maximum output voltage of 12V2A, please note before ordering!Charging and discharging at the same timeUPS power supply can be the same as the ordinary power supply for the camera to power, but also for the built-in battery to charge, wait until the power failure, the built-in battery can continue to power the camera, so that the camera continues to work,UPS with two outputs, please note: the total output current of the two output connectors is 2A.Built-in battery for power supply(not included)When the power is disconnected, the built-in battery(not included) can be powered to keep your camera working for up to 24 hours, so don't let the bad guys have a chance to take advantage of it!Better than ordinary power supplyThe UPS has a battery(not included), and there is no need to operate to switch the power supply, it continues to work after a power failure, and automatically switches to charging after power is applied, no complicated operation is needed.Compatible with 18650 batteries (flat head)You can install a rechargeable flat 18650 battery according to your own needs for useSuitable for most IP cameras and surveillanceSuitable power supply line12V 2A UPS power supply parameters