VXL-3S 3340 New Velineon ESC Cooling Fan For Traxxas Bandit Rally Slash Stampede Rustler Hoss 2WD/4X4 VXL-3s

Installation Process:1.To install the cooling fan,press the fan tabs over the VXL-3S heat sink until they snap on.2.Plug the VXL-3S cooling fan connector into the plug on the front of the cooling fan.Notes:1.The fan must blow air down across the flns.2.The fan plug should face the front of the VXL-3S3.The fan is not water resistant.4.Always turn off the VXL-3S and unplug the model battery when not in use/5.Periodically removethe fan and clean and debris from the fan and the heat sinkColor: Blue, Red, Black, GreenPackageInclude:1pcsApplication:For Rustler BrushlessFor Rustler 4X4 BrushlessFor Rustler 4X4 UltimateFor Rustler 4X4 VXLFor Slash 4X4 UltimateFor Slash 4X4 VXLFor Slash 4X4For Slash VXLFor Slash 4X4 BrushlessFor Slash 4X4 UltimateFor Slash 4X4 VXL EHDFor Slash Brushless EHDFor Slash Brushless Unassembled KitFor Slash ModifiedFor Slash VXLFor Stampede 4X4 VXLFor Stampede 4X4 BrushlessFor Stampede BrushlessFor Ford F-150 Raptor R 4X4For Ford Fiesta ST RallyFor Ford F-150 RaptorFor Ford Fiesta ST Rally BrushlessFor Ford Fiesta ST RallyFor Hoss 4X4 VXLFor 4-Tec 2.0 Brushless AWD ChassisFor 4-Tec 2.0 VXL AWD ChassisFor Jato 4X4 BrushlessFor Bandit VXLFor BIGFOOT 4X4 Brushless Officially Licensed ReplicaFor BIGFOOT No.1 Officially Licensed ReplicaFor Drag Slash 1967 Chevrolet C10 TruckFor Drag Slash Ford Mustang 5.0