Super Shark Fin Antenna Universal Auto Radio Receiving Aerial FM/AM Car Styling Suitable for Kia Rio K2 Borrego Sportage 3 Venga

p{margin-block-start: 0; margin-block-end: 0}Super Shark Fin Antenna Universal Auto Radio Receiving Aerial FM/AM Car Styling Suitable for Most Car ModelsFeatures and specifications:Chemical-FreeThis antenna is free from high-concerned chemicals, making it a safe choice for your vehicle.Universal CompatibilitySuper Shark Fin Antenna is universally compatible with most car models, ensuring a perfect fit for your car,please check your antenna base size to comfirm it.Dual Frequency SupportDesigned to support both FM and AM frequencies, this antenna provides a wide range of radio reception options.High-Quality MaterialManufactured by DA, known for its reliability, this antenna is made from high-quality materials, ensuring durability and longevity.Safety CertifiedWith its CE external testing certification, you can trust that this antenna meets the highest safety standards.Super shark fin antenna made from ABS plastic. It is coated in piano paint,Chrome Carbon and comes in 15 colors. Features a double adhesive for a strong hold.Super shark fin made from ABS plastic. Features a double adhesive for a strong hold.Shark size:Length:17.6cm/6.93inch.Width:9.6cm/3.78inch.Height:6.3cm/2.48inch.Bottom hole size:Length:15cm/5.91inch.Width:6.8cm/2.68inch.Note:The shark bottom hole measures 15cm/5.91inch x 6.8cm/2.68inch.Please make sure your antenna base is smaller than that to ensure it,otherwise,it can not install.This shark fit 98% car model,only few car model can not install. Packing list:Shark antenna body 1 piece.Screw M5x10 1 piece.Nut M5 1 piece.Double adhesive 1 piece.Shark color show:BlackWhiteMatte Blackpearl whiteSilverGrayDark GrayDeep RedCherry RedDeep BlueOrangeYellowDisplay drawing: Easy to install①Remove the original antenna,clean the area around the antenna base.② Heating double adhesive,stick the double adhesive onto the bottom of the shark fin.③ Tighten screw and nut on the original antenna base.④ Carefully align the shark fin and press down for 2 minutes to assure adhesion.Frequently Asked QuestionsQuestion 1:Is the shark same color with original car color?Answer 1:Shark fin color very close the original color,however, the car due to long-term exposure to outdoor, erosion by rain and snow,the color has changed, so impossible exactly the same as color,please understand.Question 2:The shark installed on the roof have a little gap, is appropriate?Answer 2:The shark bottom is curved,most of sedan models no have gap,the hatchback models and SUV models roof is flat,there may be have a little gap,it does not affect the use.You can use adhesive in to the gap.Question 3:How about the radio signal effect after installation?Answer 3:This antenna using purification copper fittings,through our tested,the signal close to the original car antenna.Question 4:What should be note when installing?Answer 4:Clean around antenna base,be sure not have water and dust,first connect the cable and base,test the radio,if it is ok,than installing,heating double adhesive with hair dryer before you install,it will become soft,viscosity will increase,only have one chance to paste,so be sure to alignment the positionpressing 3 minutes after pasted,keep dry in 2 days.