2PCS Switch Relay Gate Remote Control Module AC/DC 9V-30V 85-250V 2CH 300MHz to 868MHz 433MHz 12V 24V Garage Door Receiver

Universal Receiver Switch Multi Frequency 300MHz to 900MHzDescription:1)Name: Garage Door Receiver .2)Operating Voltage: AC/DC 9V-30V or AC 85-250V3)Channel: 2.4)Frequency: 300MHz - 900MHz.5)Compatible with: Rolling Code and Fixed Code & Learning code.6)Size: 5.3cm X 4.5cm X1.6cmWorking frequency: 300-900MHz(Rolling code & Fixed code)300MHz310MHz315MHz318MHz390MHz433.4MHz433MHz433.92MHz868MHz868.3MHz868.8MHzCan identify ALL Fixed code (2262, 2260, 2264, 5326, M1E, M5E and so on). All Learning code (1527, 2240, 6P20B, 6P20D and so on), Rolling code (HCS301, HCS300,HCS200, HCS201, HCS100, HCS101),Wide range of use:Garage doors, Gate Doors, Automatic barrier,Electronic gates,motorcycles, car alarm products, home security products, short-range wireless remote control products, industrial control products, Electrical appliances/Home automation,Alarm Systems etc.Feature1) Distance: 30-50 meters.2) Compatible with 95% of garage door brands on the market.3) One receiver can work with 400 codes.4) It don’t interference other remotes and receivers.5) Brand selector: With 8 dip switches user can make different combination for different remote brands.Include* Receiver* Small Antenna* English ManualHow to program - It is easy!1) Select the correct brand for remote to be programmed by moving dip switches UP or DOWN. For example 433,92Mhz Marantec remote controls, just move Dip-switch 7 UP. 2) Press the learn button. The will LED turn on. 3) Press the button on the remote, the LED flashes 4 times. It means that remote control was programmed successfully. 4) Repeat step 2 for another button.5)The 2-nd channel programming procedure is the same. Erase all data from the memory card: Press and hold either learn button. The LED will start flash. Keep this button pressed, until the LED will turn off. All saved data in the memory card will be erased permanently and can not be recoveredBrand selector: With 8 dip switches user can make different combination for different remote brands.ProgrammingProgram to Gate / Garage Door Openers the same way as original DOORHAN Transmitter 4 remotes, please refer to your receiver's user manual. For a typical DOORHAN Garage Control Panel, the programming procedure is as follows:1. Press and release the button R on the receiver.2. The left side of display panel will show 0 then disappears immediately.3. Press any button twice, coding is completed.4. Press the transmitter button to test operation.Note: To remove a single transmitter's code or all transmitter codes from the receiver memory please refer to your receiver manual.