Universal Front Car Shark Fin Antenna Radio Receiving Aerial for Hyundai i10 Getz

p{margin-block-start: 0; margin-block-end: 0}Features and specifications:Shark fin antenna made from ABS plastic. Features a double adhesive for a strong hold.Shark fin size: length 15 cm (5.90 inch), width: 8.37 cm (3.29 inch), height: 6.25 cm (2.46 inch)Note:The shark bottom hole size: 11.2cm/4.41inch x 5.16cm/2.03inch. Please make sure your antenna base is smaller than that to ensure fit. Otherwise,it can not install.Due to the increasingly narrow internal space, please check the top width of the original car antenna to avoid installation issues.Packing list:Shark antenna body 1 piece.Screw M5x10 1 piece.Nut M5 1 piece.Double adhesive 1 piece.The shark picture:Easy to install① Stick the double adhesive onto the bottom of the shark fin.② Remove the original long antenna.③ Tighten screw and nut on the original antenna base.④ Carefully align the shark fin and press down for 2 minutes to assure adhesion.FAQ:Question 1:The shark same color with the original car color?Answer:The shark fin color very close the original color,however, the car due to long-term exposure to outdoor, erosion by rain and snow,the color has changed, so impossible exactly the same as color,hope you understand that.Question 2:How do i know the shark fit my car or not?Answer:Please remove the long antenna,than check your original antenna base length,width and height.Please confirm the base length and width size less than shark bottom hole size.Meanwhile,as the height of the shark antenna increases, the internal space becomes smaller and smaller.Normal base,the top size smaller than bottom size,it can be install.If the top and bottom of your base are the same size, it may not be suitable.Due to the increasingly narrow internal space, please check the top width of the original car antenna to avoid installation issues.Question 3:The shark installed on the roof have a little gap, is appropriate?Answer:The shark bottom is curved,most of sedan models no have gap,the hatchback models and SUV models roof is flat,there may be have a little gap,it does not affect the use.You can use adhesive in to the gap.Question 4:What should be note when installing?Answer:Clean around antenna base,be sure without water or dust,first connect the cable and base,test the radio signal,if it is okay,than installing,heating double adhesive with hair dryer before you install,it will become soft,viscosity will increase,only have one chance to paste,so be sure to alignment the positionpressing 3 minutes after pasted,keep dry in 2 days.