5m Car Interior Decorative Light Strip Led Ambient Mood Lamp 5V USB DIY Flexible EL Cold Light Line Atmosphere Lighting Strip

Specification：-Plug type: USB-Length: 5 meters- Input Working Voltage：DC 5V USB power supply- Light Source：EL Electro‑luminescent Cold Light Wire- Interface：USB plug（USB plug & booster driver CAN NOT be cut）- Feature：Soft flexible cold light, low heat- Installation Method：Insert light wire into car dashboard gap- Application：Car interior decoration, home, party ambient lightingInstallation & Operating Instructions1. Installation Requirement：This light wire is installed by inserting into car dashboard gaps. Only vehicles with interior gaps are compatible.2. Unroll the cold light wire, gently tuck the light wire body into the gaps of dashboard, door panel or center console. Do not force it into too‑tight gaps to avoid crushing the wire.3. Only the light wire body can be cut. DO NOT cut USB plug and booster driver module.**4. Cutting operation：MUST cut the light wire under complete power‑off state. Use sharp scissors to cut the light wire at cutting position. After cutting, wrap the cut end with insulating tape to prevent short‑circuit.5. Plug the USB connector into 5V USB power source, such as car USB port, power bank, USB adapter.> Note：The USB unit is a booster driver. It converts low‑voltage USB input into high‑voltage power to drive the EL wire. A slight faint buzzing current sound during operation is normal working phenomenon, not product defect.6. Arrange the booster driver and excess cable, avoid being pinched by car doors, seats or moving parts.7. This light must use the original matched booster driver. Do not connect to power supply without driver. Important Warning 1. DO NOT cut or modify the USB plug and booster driver assembly. Cutting USB plug will destroy boost circuit, may cause short‑circuit, overheating or fire risk. Only the light wire section is allowed to cut.2. Cut only when power is fully disconnected.Never cut the light wire while powered on. Live‑wire cutting may cause spark, short‑circuit and permanent product damage. Always seal cut end with insulating tape after trimming.3. This product takes DC 5V as input. DO NOT directly connect to vehicle 12V/24V power without converter. Over‑voltage will instantly burn out the light wire and booster driver.4. Vehicle Compatibility Notice：Installation relies on car interior gaps. Cars without proper dashboard gaps cannot install this product.Please confirm your car has interior gaps before purchase.5. The wire can be softly bent. DO NOT hard fold, knot, squeeze or pierce the wire. Heavy squeezing in tight gaps will break internal electrode and cause partial / full light failure.Package Includes1 × 5m EL cold light wire1 × USB driver1 x scraperNote:1.Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures.2.Please allow 3-5cm measuring deviation due to manual measurement.