Universal 1D Shark Fin Antenna Car Radio Aerials FM/AM Car Styling Suitable for Subaru Impreza XV Exiga Tribeca Levorg Outback 

Shark fin antennaBy DAFeatures and specifications:Chemical-FreeThis antenna is free from high-concerned chemicals, making it a safe choice for your vehicle.Universal CompatibilityThis 1D Shark Fin Antenna is universally compatible with most car models, ensuring a perfect fit for your car,please check your antenna base size to comfirm it.Dual Frequency SupportDesigned to support both FM and AM frequencies, this antenna provides a wide range of radio reception options.High-Quality MaterialManufactured by DA, known for its reliability, this antenna is made from high-quality materials, ensuring durability and longevity.Safety CertifiedWith its CE external testing certification, you can trust that this antenna meets the highest safety standards.1D shark fin antenna made from ABS plastic. It is coated in piano paint,Chrome Carbon and comes in 15 colors. Features a double adhesive for a strong hold.Shark fin antenna made from ABS plastic. It is coated in piano paint. Features a double adhesive for a strong hold.Note:The shark bottom hole measures 10cm/3.9inch x 6.2cm/2.4inch. Please make sure your antenna base is smaller than that to ensure fit. Otherwise,it can not install.Fit these antenna base as below:New design antenna cable for a stronger signal.Packing list:Shark body 1 piece.Copper Screw M5x10 1 piece.Copper Nut M5 1 piece.Double adhesive 1 piece.Shark size and bottom hole size:Shark fin size: length 16.9 cm (6.65 inch), width: 7.7 cm (3.03 inch), height: 6.3 cm (2.48 inch)Bottom hole size: Length: 10 cm (3.94 inch), width: 6.2 cm (2.44 inch)Note:The shark bottom hole measures 10cm/3.94inch x 6.2cm/2.44inch.Please make sure your antenna base is smaller than that to ensure it,otherwise,it can not install.Color:ChromeCarbon BlackBlackPearl BlackMatte BlackWhitePearl WhiteSilverGrayDark GrayDeep RedCherry RedDeep BlueOrangeYellowDisplay drawingEasy to install① Stick the double adhesive onto the bottom of the shark fin.② Remove the original antenna.③ Tighten screw and nut on the original antenna base.④ Carefully align the shark fin and press down for 2 minutes to assure adhesion.FAQ:Question 1:The shark same color with the original car color?Answer:The shark fin color very close the original color,however, the car due to long-term exposure to outdoor, erosion by rain and snow,the color has changed, so impossible exactly the same as color,hope you understand that.Question 2:How about the radio signal effect after installation?Answer:This antenna using purification copper fittings,through our tested,the signal close original antenna.Question 3:How do i know the shark fit my car or not?Answer:Please remove the long antenna,than check your original antenna base length,width and height.Please confirm the base length and width size less than shark bottom hole size.Meanwhile,as the height of the shark antenna increases, the internal space becomes smaller and smaller.Normal base,the top size smaller than bottom size,it can be install.If the top and bottom of your base are the same size, it may not be suitable.Question 4:What should be note when installing?Answer:Clean around antenna base,be sure without water or dust,first connect the cable and base,test the radio,if it is ok,than installing,heating 3M adhesive with hair dryer before you install,it will become soft,viscosity will increase,only have one chance to paste,so be sure to alignment the positionpressing 3 minutes after pasted,keep dry in 2 days.