OBU Display Slim Mount | Low Profile 14° Bracket | ERP 2.0 | 3M VHB + Promoter Wipe | FREE OBU Cashcard Cover

Replace the bulky ball-joint bracket on your ERP 2.0 OBU display with a slim, fixed-angle mount. Cleaner windscreen, no wobble, display sits closer to the glass.WHAT YOU GET (Set 1)1x OBU display slim mount (black ABS, 3D printed)1x 3M VHB double-sided adhesive pad, pre-cut1x adhesion promoter wipe, for a stronger bond on glassFREE gift: 1x OBU cashcard cover, for a neat, flush finish on your OBU card slot (while stocks last; design may vary)Set 2 adds:1x high-quality tri-wing (Y-type) 2.0 screwdriver: chrome-vanadium steel with a magnetic tip, the exact size for OBU display screwsFEATURESLow profile: display sits max. 18 mm off the windscreenFixed 14° angle tilts the screen towards the driverCompact: 46.7 x 39.5 x 18 mmReuses the 4 original screws from your display bracketSolid one-piece block in tough ABS, built for Singapore car heatNo drilling, no wiring changesHOW TO INSTALL (about 10 minutes)Unscrew the 4 screws holding the ball-mount bracket on the back of your OBU display (tri-wing / Y-type).Screw the slim mount onto the display using the same 4 screws.Peel the red liner off the 3M pad and stick it on the mount.Clean the windscreen spot with the adhesion promoter wipe and let it dry for about 1 minute. Press the mount firmly onto the glass for 30 seconds. Leave 24 hours before heavy use for best adhesion.See the install video in the listing.PLEASE NOTEOBU display NOT included.Product photos are of the actual mount. In-car and installation images are 3D illustrations.Install at your own discretion. Do not block your view of the road.DIY: no installation service.Questions? Chat with us before buying!