XMSJ | High Frequency Vibration Feeder Clockwise Precision Base Circular Pure Copper Coil Circular Feeder Clockwise Anticlockwise

Model: 100# Mounting hole: M8 Upper diameter: 100 Lower diameter: 105 Height: 95 Matching foot pad: 25*20 (M8) Power: 30w Working voltage: AC220V Suitable upper plate diameter range: 100-150mmInstallation, maintenance, and use of the base1. When opening the packaging, the entire machine and accessories should be checked for compliance.2. Check whether the fasteners of each part of the host are loose.3. During installation, it is necessary to ensure that the vibration damping components (rubber pads) are in the corresponding holes above and below.4. After adjusting the height and level of the vibration disc, fasten the lower seat to the bracket or fixed plate. 5. There should be a certain gap when connecting the outlet of the vibration disc with the counterpart to avoid affecting the function of the vibration disc. 6. The vibration disc is an electrical plug installed on the electrical control box (note: the electrical control box must be waterproof and oil proof). Connect the 220V or 110V power supply, turn on the switch, slowly rotate the potentiometer, and gradually reach the required feeding quantity.7. After two years of normal operation, the vibration disc should be disassembled from various parts of the chassis, cleaned of dust and dirt on each component, reassembled and debugged to achieve the required feeding quantity.Attention: Before connecting the power, be sure to adjust the potentiometer to the minimum value to avoid damaging the thyristor. The gap between the electromagnet and the armature (0.5-1.2mm) has been adjusted before leaving the factory, and generally does not need to be adjusted again. Common faults and troubleshooting methods1. After connecting the power supply, there is no vibration. Check whether the fuse of the electronic controller is blown, whether the electrical components are loose, and whether the plug and socket have poor contact.2. The speed is not enough(1) Check if the screws fastening the elastic components are loose.(2) Is the gap between the electromagnet too large? The normal gap for the electromagnet and armature of a small vibrating disc should be within the range of 0.5-1.2 millimeters, and the non parallelism between the working surface of the iron core and the armature should not exceed 0.02 millimeters. (3) Whether the shrapnel is broken.3. The temperature rise of the electromagnetic coil is too high or the coil is burnt out.(1) The gap between the iron core and the armature is too large, which can easily lead to coil burning. Do not set the scale of the vibration disk speed controller above 200, as this will cause the coil to heat up and burn out. If the vibration force of the vibration disk is not enough, adjust the spring plate (increase or decrease the spring plate).Electromagnets suitable for full wave vibration may experience high temperature rise (2) if used for half wave power supply.